The bottom is the same situation except the Dynamite is plugged into the Shure.the difference is mind blowing!įurthermore, the cylindrical box the DM1 comes in is suuuuuch a nice touch. The top of the two tracks in my screenshot is with the Focusrite Scarlett Solo 3rd gen gain at 75% and my lips right up to the Shure sm7b. I did couple test recordings to showcase how vast of a difference there is with and without the Dynamite. Furthermore it adds slightly more clean gain than the Cloudlifter from what I researched. What sold me on the DM1 was the fact that it plugs in directly and thus eliminates the need for an extra xlr cable. So I was debating getting the Cloudlifter or the Dynamite. This is hands down an incredible gift from the audio gear gods! Additionally, the DM2 offers a roadworthy, slim, all-metal design, ensuring reliable operation for onstage applications in difficult environments. The active preamp requires 48V phantom power for operation and is built with a dedicated output buffer amplifier that reduces RF interference, buzz, and hum while allowing it to drive long cable runs. The sophisticated Class-A design and FETs provide clean gain with low self-noise. The DM2 offers eight load-impedance settings, allowing you to properly match your microphone and preamp combination and find the sweet spot for optimal results. A switch allows you to select between 15 and 30 dB of gain to boost the audio signal, improving the level to your preamp, mixer, or audio interface without adding noise or coloring the sound.
The DM2 TNT Active In-Line Microphone Preamplifier from sE Electronics is intended to be inserted between a passive ribbon or dynamic microphone and a microphone preamplifier (sold separately) to provide gain for the microphone signal.
Its output impendence is also the lowest in its class, allowing it to drive long cable runs while reducing susceptibility to RF interference, buzz and hum. The DM1 is the perfect way to boost the signal from a passive mic, reduce the likelihood of interference, and provide significantly improved level to your preamp - all without adding noise or coloration. Additionally, the gain it provides is always a consistent 28dB regardless of the connected load, thanks to its dedicated buffer amplifier. With a sophisticated class-A design and specially-selected high-grade FETs, the DM1 has vastly lower output impedance and nearly half the noise of anything else on the market. The DM1 DYNAMITE is an ultra-slim active inline preamp that fits seamlessly between your mic and mic pre, providing a massive +28dB of clean, transparent gain for all your dynamic and passive ribbon microphones. Some mics need a LOT of gain - and not all preamps are up to the challenge. The DM1 Dynamite: explosive level for all your passive mics
0 kommentar(er)
